3M Clear Paint Surface Protection Bulk Film Roll 6-by-84-inches

Very happy with this. I cut strips with scissors then used it on my doorjambs and door edge to protect against dings. I never used PPF before but it was pretty easy to apply with soapy water spray, my fingers, and a rag. Getting it to slit flat around slight curves was tricky but doable and it came out looking almost professional. Very happy with the results. Glad I went with quality 3M and not some no-name brand that probably doesn't stretch as well.

Amazing product . If you know how to install and have the correct tools and spray with squeegee it works amazing .

Good product . I used it on headlights after cutting according to the headlamp shape.

The product was used to apply a 12" strip across the hood of a new Ford truck. It WORKS well. It is NOT, however, ANYWHERE NEAR as easy to install as the installation videos on the Internet would lead you to believe.Be sure and have (or get) a squeegee for applying this stuff, and make sure you have plenty of soapy water (mixed according to the installation instructions) and alcohol water (again, mixed according to the instructions. Be VERY patient, and allocate WAY MORE THAN ENOUGH TIME TO DO THE INSTALLATION. AND, be SURE to have someone to help 'cause if you try to install this by yourself you may find it WAY more difficult than necessary.The truck on which it was installed has a simple hood configuration with virtually no difficult curves or tight corners, so my expectation was that installation would be very simple - ESPECIALLY after watching SEVERAL installation videos that applied the stuff to MUCH more difficult configurations than mine......Eventually, we got it installed, and for the most part, it looks good... There are some flaws, especially along the edges, but they're not real visible...SO, on a 1-10 scale, for protection, I give it a 9. For ease of installation I give it a 3... It's not as difficult as overhauling an engine, but it's also not as easy as applying window tint!

excelente producto

Used it on my mountain bike. Easy to install and works well.

The 3M Clear Paint Surface Protection Film does its job well—it’s practically invisible once applied and provides solid protection for my car’s paint. However, installing it on curved areas like the hood was quite a challenge. The film is tough to get smooth over curves, so it takes some patience and careful work to avoid bubbles and wrinkles.If you’re planning to install this on a flat surface, it should be much easier. But for curved sections, just be prepared to take your time. Overall, it’s a high-quality film that’s worth the effort for the protection it offers.

Thicker than appears on the roll. If have never worked with this before ... go line and watch a few videos ... bubbles will drive you nuts. Videos show how to deal with them. This material is some what forgiving. As was applying, to get it where I wanted it to lay, on compound curved surfaces, I was able to lift, trim and, lay it back in place. I had told a friend about it. He came over to see how I was going to go about applying it. He had forgotten that I had done it the day before. He was checking out where I had told him I was going to use it and, until I pointed it out, he did not see that I had already applied it. Installed properly, this stuff practically disappears. In the right light, especially when one already knows, one can see the edges. Otherwise, lilke my friend saw, is practically invisable. Time will tell if it yellows in the sun. I think it should be fine. Is why I bought 3M brand, instead of a cheaper knock off. I bought and used the Rapid Tac spray ... I found no advantage to using the spray. Perhaps if I was doing a larger area ( say the size of car trunk lid or something ) may have been beneficial. I was covering several areas roughly 7" x 24".