Mr. HeaterF242010 MH4GC 4000 BTU Golf Cart Heater, Wind-Resistant With ODS And Tip-Over Safety Switch & Cup Holder Adapter - Silver and Black

A lot bigger than I thought it would be, but def gets super hot. I love it.

Great for a side by side too.

Perfect heating up golf cart cab quick. Nice for freezing fingers.

It is very warm but doesn't fit every cup holder!

Owned this for a few years. Fires right up and keeps me warm

Read the instructions and it works like other propane appliances I have.Got out a brand new 1lb cylinder and connected it. Pressed the "ON" button several times and then heard a slight whisper. Waited Ten minutes and the ceramic was not even red. I could put my hand on the metal grill without being burned.Changed to another new 1lb propane cylinder. Started it again and held the button longer this time. Let it sit 5 minutes and the ceramic turned slightly red. Let it run another 5 minutes without much change. Looked underneath thru the vent holes and saw the pilot burning very lightly, but no other larger flame.I had this thing running in my garage where it was 64F and it could hardly heat my hands right in front of it.The top of the metal ring around the ceramic plate had some discoloration, but not sure if it was from testing at factory or someone else that bought it and had similar results before returning it.I have a call into the factory since AMAZON said it was non-returnable. ?????????There is a spring loaded plunger shown in picture #2 in the center of mounting threads and I thought it might not being depressed enough to allow more gas to flow into burner. Both cylinders i tried were snug against shoulder.

My cup holders are by the middle armrest so that wouldn’t work…so I just rigged up a box and some straps to hold it in place for now. Haven’t been on too bumpy of a road yet so not sure if the tip over thing will kick it off yet or not. So far the dogs are much happier too. Make sure the propane tank is completely tight. I didn’t at first and almost had a fire. Flames came out from under the plastic main part. But there is an easy OFF button ontop next to the On button. Once tightened better it worked fine. Wouldn’t trust it alone though. Turn it off if you leave your rig. 2024 Wolverine x2 1000 rspec

Frustrating! Because of the tip over protection, ANY bump causes it to turn off. A friend who has one as well said that we need to use bungie cords to hold it in tighter. We will see if that fixes it. The heater itself put off a lot of heat. We just can’t use it while we are moving.